This adapter provides CAN-Hi, CAN-Low, ignition switched power, and ground to a 4-pin Deutsch DTM connector. A second cable (purchased separately or user created) is required to go from the 4-pin connector to your datalogging device(s) such as AiM, Solo(2) DL, AEM, MoTeC, RaceCapture/Pro, etc.
Options: Always-On power receives constant 12V power from the battery, Ignition-On is powered only when the ignition switch (or key) is set on. The 2-pin adapter provides only CANbus connections, the installer must run power and ground to the logger device.
Note: Only for vehicles with Dynamic Stability Control (DSC) [Mk20 or Mk60 ABS]
This adapter splices into an existing circuit of the vehicle (steering angle sensor) with approximately 2.5-3A of power available (each vehicle can vary slightly). If your device(s) will use this much power or more, please consider the 2-pin version that only provides a CAN-Bus splice, then wire separate power and ground to your device(s).